Why most home wind turbines get sited on the wrong side of the house
I get asked some version of this question every few weeks: "I've picked a spot for the turbine, can you just check the tower height?" And almost every time, the spot was picked for the wrong reasons. Closest point to the shed. Cheapest cable run. Not blocking the view of the dam. Hardly ever is it picked because that's where the wind actually is.
We run a small micro-hydro system here, not wind, but our property sits in a valley that funnels air in a particular direction depending on the season, and I've spent a fair bit of time with an anemometer up a ladder trying to work out why the breeze that rattles the tin roof never seems to show up where I actually want to put anything. Siting is the one decision in a small wind project you genuinely can't undo cheaply afterwards. Get the tower height wrong, you can sometimes extend it. Get the position wrong, you're digging a new footing.
The default siting logic is backwards
Most homeowners, and I'd say most installers working from a sales brief rather than a wind assessment, start from the house and work outward. Where's the shortest cable run to the switchboard? Where's a spot that won't annoy the neighbours? Where does the council setback actually allow a tower? All reasonable questions, but they're third-order questions. The first-order question is simpler and gets skipped constantly: where on this property does wind arrive clean, and where does it arrive chopped up by terrain and buildings?
I've written before about how the wind resource map is lying to you, and the siting problem is the on-the-ground version of that same mismatch. A regional average tells you the district has decent wind. It tells you nothing about whether your particular paddock, ridge or rooftop sees that wind cleanly or whether it's been torn apart by the time it reaches your fence line.
Read the land before you read the spec sheet
The exercise I actually walk clients through, and the one I did on our own block before we gave up on wind entirely and went hydro, is to stand at the proposed turbine location on a windy day and look at what's upwind for roughly 150 to 300 metres in the prevailing direction. Trees, sheds, the house itself, a ridgeline, even a dense hedge row. Each of these creates a wake, and that wake extends a lot further downwind than people assume, often ten to twenty times the height of the obstacle.
So a 10-metre shed doesn't just mess with wind for a few metres behind it. It can still be stealing 15 to 20 percent of available energy, and adding meaningful turbulence, 100 metres further on. If your intended tower site sits anywhere in that shadow, no amount of tower height solves it cleanly, you just end up needing to go taller than you budgeted for, which is the exact trap I cover in why tower height matters more than turbine size.
The practical version: walk the property boundary in the direction the wind usually comes from (your nearest Bureau of Meteorology or NOAA station wind rose will tell you the dominant direction for your region) and find the point furthest from obstructions, not the point closest to the house. Then work backward from there on cable run and access.
Elevation doesn't always mean exposure
A mistake I see constantly, usually from people who've read one too many generic siting guides, is assuming the highest point on the block is automatically the best wind site. Sometimes it is. Often it isn't. A high point tucked behind a taller neighbouring ridge, or one that sits in the lee of a tree line that was planted forty years ago and has since grown out, can be worse than a lower, more exposed spot on the same property.
On our place, the obvious high point is actually one of the more sheltered spots because of how a stand of mature eucalypts has grown up on its western edge over the decades since the original owners planted a windbreak. The genuinely exposed ground is a modest rise on the eastern boundary that nobody would pick by eye. I only found it by actually logging wind speed at two sites for about six weeks with a cheap data logger, which is tedious but it's the only way to settle an argument that otherwise comes down to guesswork.
If you're not willing to log data for weeks, at minimum get out there on a properly windy day, the kind where the forecast says 25 to 35 km/h sustained, and physically compare how the air feels and sounds at two or three candidate spots. The difference is often obvious once you're paying attention rather than assuming.
The distance-from-house trade-off nobody budgets for
Once you've found the genuinely good wind site, you'll often discover it's further from the house than anyone wanted. This is where I see projects quietly get compromised, the siting gets dragged back toward the house to save on cable and trenching cost, and the turbine ends up somewhere between "ideal" and "convenient" that satisfies neither.
I'd rather see someone spend an extra thousand or two on heavier gauge cable and a longer trench run than permanently sacrifice annual energy yield for a shorter conduit. Wind energy available scales with the cube of wind speed, so a site with even 15 percent more average wind speed than the convenient alternative can produce 30 to 40 percent more energy over a year. No cable upgrade costs anywhere near that in lost production over the turbine's working life. I've covered the mechanics of this trade-off in more detail in how far your turbine needs to sit from the house, and why, which also gets into the noise and safety setback side of the equation that overlaps with but isn't identical to the resource-quality question.
Don't treat your own rooftop as a free lunch
Roof-mounted small wind turbines get marketed on the idea that you're "capturing wind that's already there, no extra land needed." In practice the roofline of a typical house creates one of the messiest wind environments on the entire property, turbulent, directionally inconsistent, and subject to constant gusting rather than steady flow. I've gone through the mechanics of this in what turbulence off your own roofline does to a home wind turbine, but the short version for siting purposes is: if your only candidate location is attached to or immediately above the house, you're very likely looking at a turbine that spends most of its operating life in turbulent inflow it was never rated to handle well. That shortens bearing life and tanks real-world output versus the spec sheet number.
Match siting to what your bill actually needs, not what looks good
Before committing to a site, I'd go back and actually read your last twelve months of bills properly, not just the total. What I mean by that is laid out in what your energy bill actually tells you before you buy a home wind turbine, but the siting-relevant point is this: if your household load is heavily evening-weighted and your best wind site only produces well during afternoon sea breezes, you're generating at the wrong time relative to your usage, and your export economics become the deciding factor rather than your self-consumption. That changes which site is "best" because it changes whether you're optimising for total annual kWh or for kWh produced when you'd otherwise be drawing from the grid.
This is also where council planning intersects with siting rather than following it. Setback rules, height overlays and in some council areas specific wind-turbine development controls will sometimes rule out your best wind site entirely before you get to choose, which is the whole subject of council approval for a home wind turbine: what actually gets assessed. I'd check the overlay before you fall in love with a site, not after.
A short, honest checklist before you dig a footing
Walk the likely wind direction for the full length of your property, not just near the house. Identify every obstruction taller than about 3 metres within 150 metres of each candidate site and estimate its wake. If you can afford six weeks with a simple logging anemometer at two sites, do it, the data settles arguments cheaper than a wrong footing. Weight distance-from-house against energy yield honestly, cable is cheap compared to lost production. And check the planning overlay before any of the above becomes emotionally attached to a particular corner of the yard.
None of this is exotic engineering. The U.S. Department of Energy's small wind guidance and Australia's Clean Energy Council both publish reasonably sober material on siting fundamentals, and neither pretends there's a shortcut around actually measuring your own site. I reckon the siting conversation gets rushed because everyone wants to get to the turbine selection and the economics, which are the fun parts. But the fun parts don't matter much if the turbine's sitting in somebody's wind shadow.
— Grace Lindqvist, Wind, hydro & off-grid writer, IceWarm
Common questions
- Is the highest point on my property always the best wind turbine site?
- Not necessarily. Elevation helps, but a high point sheltered by a taller ridge or a mature tree line can produce worse wind than a lower, more exposed spot. I've seen this reverse the obvious choice on my own property after logging data for a few weeks.
- How far should a turbine be from obstructions like trees or sheds?
- As a rough rule, wake turbulence from an obstruction can extend ten to twenty times its height downwind, so a 10-metre shed can still be affecting wind quality 100-200 metres away. Candidate sites inside that shadow usually need a taller tower to compensate.
- Should I pick my site based on cable run distance from the house?
- I wouldn't make that the deciding factor. Because wind energy scales with the cube of wind speed, a site with modestly better wind can produce 30-40% more annual energy than a more convenient one, which almost always outweighs the extra cost of a longer cable run.
- Can I trust my regional wind resource map to pick a site?
- Treat it as a starting point only. A regional average doesn't capture what's happening at your specific fence line, paddock or rooftop, which is why walking the property and ideally logging actual wind speed at candidate sites matters more than the map.
Grace lives off-grid on a property with a micro-hydro system and writes about wind, hydro and the realities of generating your own power.
Off-grid homeowner; renewable-energy hobbyist.
More from Grace Lindqvist
- The tower height nobody budgets for on a home wind turbineMost home wind turbine quotes undersell tower height to hit a price point. Here's why that number matters more than the turbine itself.
- What your insurer asks about a home wind turbine before you install oneBefore you put a tower up, your home insurer will have questions. Here's what they actually ask, and the gaps that can leave you exposed.
- The council noise complaint nobody warns you about before you buyA home wind turbine noise complaint isn't about decibels on a spec sheet. It's about your neighbour, your council's process, and tonality.
- The swept-area math most home wind turbine buyers skipBlade length, not rated kW, decides how much energy a home wind turbine actually captures. Here's the swept-area sum most buyers never run.
- Why a wind turbine's rated kW number tells you almost nothingA home wind turbine's rated kW is measured at wind speeds your block may never see. Here's what to check instead before you buy one.
- Checking your title deed before you buy a home wind turbineBefore you spend on a home wind turbine, check your title for covenants and easements — they can override council approval entirely.