Selling excess wind power back to the grid: what's actually realistic
I get asked this at least once a month, usually by someone who's just had a solar quote and is wondering whether a small turbine could do the same trick: stick it up, connect it, and watch the retailer's cheque roll in. The honest answer is that grid export for residential wind works completely differently to solar, and most of the assumptions people bring across from rooftop PV don't survive contact with how a wind system actually behaves. I run micro-hydro on my own property rather than wind, but I've spent years around neighbours and clients on this exact question, and the gap between what people expect and what they get is consistent enough that it's worth laying out properly.
Feed-in tariff arrangements for small wind exist in most jurisdictions that already support solar export, but the eligibility criteria, metering requirements and actual dollar return are a different beast entirely. If you're weighing up whether a home turbine will pay for itself partly through export credits, you need to understand three things before you get anywhere near a contract: how your output profile compares to your household's own demand, what the retailer's connection agreement actually asks of a wind generator specifically, and why the economics rarely resemble a solar payback spreadsheet.
Why wind export doesn't behave like solar export
Solar has a predictable, bell-shaped output curve that roughly lines up with daylight and, in most homes, at least partially with daytime demand. Wind doesn't do that. It's erratic by nature, gusty for twenty minutes then dead calm for six hours, sometimes strongest at 2am when the house needs almost nothing.
That mismatch matters enormously for the economics. A rooftop system with a north-facing array might self-consume 30-40% of its output even without a battery, because generation and demand overlap for a big chunk of the day. A small wind turbine on an exposed ridge might generate its best output overnight in a winter low-pressure system, when the house is drawing almost nothing and everything above baseload gets exported at whatever rate the retailer offers, which for wind is often lower and less favourably structured than the solar tariff on the same account.
I'd argue this is the single most misunderstood part of small wind economics. People run the numbers using their solar export rate as a proxy, assume similar self-consumption, and end up with a projected payback that has almost no relationship to what actually shows up on the bill eighteen months in.
The metering problem nobody mentions upfront
Most retailers and network operators built their small-generator connection processes around solar because that's 95%+ of the applications they see. When a wind system application comes in, it often gets routed through the same paperwork, but the technical assessment can be more involved because output variability and voltage behaviour differ from a smoothly-inverted solar signal.
Some networks want additional information on the turbine's inverter or controller, its shutdown behaviour in high wind, and how it handles rapid gust-driven output swings, before they'll sign off on export approval. This isn't a conspiracy against wind, it's just that the standard interconnection paperwork and the standard technical review checklist were written with PV in mind, and a wind system sometimes needs a manual look rather than an automatic tick. Budget extra weeks for this, not days, and ask your electrician up front whether they've actually connected a wind-export system before, not just solar. It's a genuinely different scope of work.
What the export numbers actually look like in practice
I've seen owners with small turbines on decent sites, genuinely good average wind resource, end up exporting a smaller share of their annual generation than they expected, simply because so much of the output arrives at night or during storms when the house draws little and the export credit per kWh is modest. The generation might be real and useful, but "useful" and "financially transformative via export" are different claims.
Contrast that with a household that runs a home battery alongside the turbine. In that setup the battery absorbs the erratic overnight and off-peak wind output, and the household draws down stored energy during evening peak instead of buying it from the grid. That's arguably where small wind's economics actually work, not through export credits at all, but through self-consumption timed by storage rather than by the wind. If you're already thinking about a battery for solar smoothing, our piece on sizing battery capacity for self-consumption vs backup is relevant here, because a wind-charged battery is sized around a different generation curve than a solar-charged one, and the battery sizing approach for wind and hydro systems covers that distinction directly.
Reading your own bill before you model anything
Before spending money modelling turbine output against a retailer's tariff sheet, go back to basics and actually read what your bill tells you about your load shape. Most retailers now show hourly or half-hourly usage online, and that data is worth more than any turbine manufacturer's brochure curve. If your evening peak is the dominant cost driver, wind export credited at a flat daytime-equivalent rate won't move the needle much; what will move it is storage that lets you use the wind energy when you'd otherwise be buying grid power at peak rates. We've written more generally about this in what your energy bill actually tells you before you buy a home wind turbine, and it's genuinely the first homework step, before council approval, before turbine choice, before any of it.
Contracts, meter types and the fine print that trips people up
A gross meter records everything a system generates and everything the house imports separately; a net meter just nets the difference. For solar, retailers are used to net arrangements because self-consumption dominates. For wind, because so much output can land off-peak, some retailers push a net arrangement that quietly undervalues generation the homeowner assumed would show up as export credit, because it was consumed instantly rather than metered separately. Ask specifically, in writing, whether your proposed connection is gross or net metered, and get the export tariff rate for the wind generation category specifically, not the blended solar-and-wind number sometimes quoted verbally by a call centre rep who's mostly fielding solar enquiries. It sounds pedantic. It isn't; it's the difference between a contract that reflects reality and one that quietly shortchanges you for years.
Where export actually makes sense versus where it doesn't
Export-driven wind economics tend to work best on rural or semi-rural properties with genuinely strong, consistent wind resource, a modest household load, and a retailer or network with a mature small-wind connection process, which in Australia and the US usually means somewhere that's already processed a reasonable volume of small wind or micro-hydro connections and has staff who don't need to look it up from scratch. They tend to work worst in suburban settings where the turbine is undersized for the site because of setback and setback distance requirements, where roofline turbulence is already dragging down output, and where the household's own demand curve doesn't leave much room for meaningful export in the first place. If that's your situation, I'd genuinely look at whether the capital is better spent on a bigger solar array plus battery, which is a mature, well-understood economic picture, rather than a wind system chasing an export tariff that may not reward it the way the sales pitch implies.
The regulatory side you can't skip
Grid connection approval for any embedded generator, wind included, sits under your network's inverter and generator connection standards, which in Australia trace back to AS/NZS 4777 for grid connection of energy systems via inverters, and in the US typically to IEEE 1547 as adopted by the local utility's interconnection tariff. Your installer should be citing these documents specifically when they talk about compliance, not waving vaguely at "Australian standards" or "code requirements." If they can't name the standard, that's worth pausing on. Combine that with the council planning process covered in our piece on what actually gets assessed for council approval, and you've got the two regulatory gates that need clearing before export economics are even relevant.
For general background on interconnection requirements for small renewable generators, the US Department of Energy's interconnection basics page is a decent primer, and the Clean Energy Council's accredited installer guidance covers the Australian equivalent for grid-connected small generation.
None of this means small wind export is a bad idea everywhere. On the right rural site, with a realistic tariff and a battery doing the timing work, it can genuinely offset a decent slice of a power bill. It just isn't the copy-paste version of solar export that most sales conversations imply, and the households that end up happy with the decision are usually the ones who read their own load data and the connection contract before they read the turbine spec sheet.
Common questions
- Can I get the same feed-in tariff for wind as I do for solar?
- Sometimes the published rate is identical, but the practical return usually isn't, because wind output timing rarely overlaps with household demand the way solar does, and some retailers apply different metering or contract terms for wind generators specifically. Always ask for the wind-specific export rate in writing rather than assuming it matches your solar tariff.
- Do I need a different type of meter for a wind turbine than for solar?
- Not necessarily a different meter type, but you should confirm whether your connection will be gross or net metered, since wind's overnight and off-peak output pattern can be undervalued under a net arrangement compared with solar.
- Is a battery worth adding to a small wind system just for export reasons?
- It's usually worth adding for self-consumption timing rather than export value directly. A battery lets you use wind-generated power during evening peak instead of exporting it cheaply overnight and buying it back at a higher rate later.
- What standards should my installer reference for a wind grid connection?
- In Australia that's AS/NZS 4777 for inverter-connected energy systems; in the US it's typically IEEE 1547 as adopted through your utility's interconnection tariff. An installer who can't name the relevant standard is a red flag.
Grace lives off-grid on a property with a micro-hydro system and writes about wind, hydro and the realities of generating your own power.
Off-grid homeowner; renewable-energy hobbyist.
More from Grace Lindqvist
- The tower height nobody budgets for on a home wind turbineMost home wind turbine quotes undersell tower height to hit a price point. Here's why that number matters more than the turbine itself.
- What your insurer asks about a home wind turbine before you install oneBefore you put a tower up, your home insurer will have questions. Here's what they actually ask, and the gaps that can leave you exposed.
- The council noise complaint nobody warns you about before you buyA home wind turbine noise complaint isn't about decibels on a spec sheet. It's about your neighbour, your council's process, and tonality.
- The swept-area math most home wind turbine buyers skipBlade length, not rated kW, decides how much energy a home wind turbine actually captures. Here's the swept-area sum most buyers never run.
- Why a wind turbine's rated kW number tells you almost nothingA home wind turbine's rated kW is measured at wind speeds your block may never see. Here's what to check instead before you buy one.
- Checking your title deed before you buy a home wind turbineBefore you spend on a home wind turbine, check your title for covenants and easements — they can override council approval entirely.